Inorganic Floor Paint

Appearance: Bright green, sky blue, gray

Water-based/Oil-based: Water-based

Packaging/Specifications: 20KG

Features

Features/Technical Parameters/Performance

Chemical Bonding and Curing: Silicates react chemically with the substrate to form a ceramic film (Mohs hardness ≥ 7)

Composition: Low VOC, solvent-free (complies with GB 50325-2020 Class I)

Extreme Environmental Resistance: Acid and alkali resistant (pH 1-14), salt spray resistant ≥ 3000 hours, high temperature resistant to 1200°C (short-term)

Breathable and Water-Resistant: Microporous structure allows moisture to escape from the substrate (suitable for concrete with a moisture content ≤ 4%)

Mechanical Properties: Compressive Strength ≥ 80 MPa, Abrasion Resistance (TSA) ≤ 50 mg (1000 revolutions/1 kg load)

Application Suitability: Applicable by spray or roller, surface drying ≤ 30 minutes (25°C), recoating interval 2-4 hours

Application scenarios

Industries/Typical Applications

Heavy Industry: Chemical plant workshops, electroplating lines, battery manufacturing workshops (hydrofluoric acid resistant)

Food and Pharmaceutical: GMP cleanrooms, cold storage floors (remains flexible at -40°C), wine fermentation tanks

Public Safety: Underground parking lots (A1 fire protection), substations (antistatic), tunnels (mildew and antibacterial)

Special Environments: Offshore platform decks (salt spray resistant), nuclear power plant auxiliary areas (radiation pollution resistant), waste incineration plants (corrosion resistant)

Precautions

1. Key Construction Controls

Surface Preparation:

Sandblast to Sa2.5 (ISO 8501-1) or mechanically polish.

Moisture content ≤ 4% (CM test method). Cracks must be repaired in advance.

Material Mixing:

Mix the two components in a strict 4:1 weight ratio. Electric agitation for 3 minutes (400-600 rpm).

Potency ≤ 60 minutes (25°C). Residual material cannot be recycled.

Environmental Requirements:

Application temperature 5-35°C, dew point difference ≥ 3°C.

Relative humidity ≤ 85% (dehumidification required for high humidity environments).

2. Safety Protection

Risk Type/Protection Level

Alkaline Corrosion: Wear chemical goggles (ANSI Z87.1), alkali-resistant gloves (butyl rubber), and protective clothing (Type 4 or higher).

Dust Control: Use a closed mixing system or a P100 dust mask.

Working at Height: Use non-slip shoes (EN ISO 20345) and a fall protection system (EN 361).